Forum

Share:
Notifications
Clear all

Auto-leveling under firmware 1.1.2?

   RSS

0
Topic starter

Anyone have trouble using the Auto-Level button under firmware 1.1.2?  On mine, nothing happens when I press the button on the screen.  I re-flashed V1.1.1 and it started working again.

2 Answers
0

Same here but anyway, I use Octoprint and in the terminal tab I send the "G29" command to stat the autobed leveling.

Another solution is to insert G29 (just after G28 (which is the home command) in the slicer software so it is included automatically in the Gcode file.

A third solution is just to open the generated Gcode file and insert in the top G28 (if it's not already there and just below G29

0
Topic starter

Interesting that the robin_nano35_cfg.txt file sets up the auto-leveling command button to call G29, but the button doesn't work. If G29 works when called elsewhere, then there much be a bug in the button itself.

Share: